Installation Guide

Date : October 18th 2019
DM3G Low-band
Ref : Installation Guide
Edition 1.2.0
Page
22/27
- Place MCE on its support.
- Plug the wired MCE RJ45 connector to the RJ45 connector of DM3G power cable.
o In case of BT MCE, plug the RJ45 from MCE charging support to RJ45
connector of DM3G power cable.
- Remove protective film from micro-keypad screen.
8 Bluetooth Option
Following elements are provided with Bluetooth option :
MCE3G BT
MCE charger
support
BT antenna for
DM3G
Bluetooth antenna must be screwed onto DM3G device.
8.1 MCE Charging
MCE is charged through its support connected to DM3G power cable through RJ45 connector.
Support is powered with +12VDC voltage through RJ45.
- Connect RJ45 connector from MCE BT support to DM3G power cable.
- Place MCE on its support and check that red LED (charge indicator) on top of MCE is
lit up. LED lights off when MCE is fully charged.
MCE BT charging indicator.