Installation Guide

Date : October 18th 2019
DM3G Low-band
Ref : Installation Guide
Edition 1.2.0
Page
21/27
7.5 Wired or BT MCE
The MCE micro-keypad can be installed on its support with the patella mounting.
The setup can be made on the car dashboard, above the gear shift with the keypad turned to
the driver or passenger.
Examples of MCE fastening : MCE BT is powered from cigarette lighter and placed between front
seats (top view, left image) ; MCE BT is fastened on storage rack between seats (right image)
Take care not to damage airbags or electric beam when you drill.
Note : In case DM3G power cable is not long enough to reach mobile terminal an extension
cable (see paragraph 4.2) is available as reference : EDMR_DM_CAB40.
1. Assemble two parts of patella with a nut, a
washer, and the M8x450 thumbscrew.
2. Assemble the patella and the MCE
support with a washer and a thumbscrew
M8x250.
3. Attach patella pedestal on dashboard with 3 iron
screws (not included) covering M8 nut.
4. Screw the whole set on the pedestal.
Dashboard
washer