User's Manual

2. Wire the DC power connector (Cinch 4 pin female) directly to the battery if
possible. Do not use the present vehicle wiring. Use #12 AWG if possible and
certainly no lighter than #14 AWG. To avoid a possible fire, or other possible
damage, make sure a fuse or circuit breaker is installed at the battery end of
the wire. Use the same size as the internal fuse listed in table I.
Attach DC input wires in accordance to the diagram in figure 3. If wires are
too large for the holes, solder them to the sides of the blades.
Figure 3. DC connector internal wiring
3. Connect the antenna to the “RF OUT” terminal with a 50Ω coaxial cable and
a PL-259 male connector according to figure 4.
4. Turn off your radio transceiver. Connect it to the “RF INPUT” terminal with
a 50Ω coaxial cable.
Figure 4. Antenna connection