Product Manual

ManualsBrandsTPI ManualsEvaporative Coolers + Misting FansPortable Self Contained Power Mister Cart — 18in., 5750 CFM

Issue Date: 3-11-05 Rev. Date: 9-12-07 Rev. Level: 13 ECN: n/a OIPM P/N: 3420433

Page 1 of 8

1200 North Main St.

Fostoria, OH 44830

Phone: 800-495-4525

Fax: 419-435-0842

www.tpicorp.com

SELF-CONTAINED POWER MISTER

MODELS: PM-18FO, PM-18S, PM-18C

IMPORTANT SAFETY

INFORMATION INSIDE

• Serious injury or death possible.

• Read, understand, and follow all

safety information and

instructions in this manual before

using or servicing this product.

• Retain these instructions for

future reference.

CONTENTS

Specifications Pages 2,3

PM-18C Assembly Pages 3,4

Set-up / Operation Pages 5,6

Replacement parts

Maintenance

Page 7

Page 8

Warranty Page 8

PM-18FO

PM-18S

PM-18C

If you have questions about the

product you have purchased or would

like to leave us feedback please

www.fostoriaindustries.com

or by calling 1-800-495-4525.

Summary of content (8 pages)

PAGE 1
If you have questions about the product you have purchased or would like to leave us feedback please contact us via our website www.fostoriaindustries.com or by calling 1-800-495-4525. 1200 North Main St. Fostoria, OH 44830 Phone: 800-495-4525 Fax: 419-435-0842 www.tpicorp.com SELF-CONTAINED POWER MISTER MODELS: PM-18FO, PM-18S, PM-18C PM-18FO PM-18S PM-18C IMPORTANT SAFETY INFORMATION INSIDE CONTENTS • Serious injury or death possible.
PAGE 2
THANK YOU!! Thank you very much for selecting TPI Corporation’s self-contained power misting equipment for your comfort conditioning needs. These products were engineered with the most reliable components and materials available and are equipped with features to assure ease of mobility, use, and maintenance. The cool air you will now enjoy when using this misting equipment is created through the process of evaporation. Heat is required to change water from a liquid to a gas or “water vapor”.
PAGE 3
SPECIFICATIONS (continued) MODEL: PM-18S • One 18-inch fan head with white powder-coated guard mounted on a yoke attached to the pump enclosure. • An integral ground fault circuit interrupter (GFCI) is attached to the power cord. • Equipped with a power cutoff tip switch. • One extra nozzle and two plugs included. • A 10-gallon Igloo cooler is included for use as water reservoir. • Shipped in two cartons and ready to assemble.
PAGE 4
PM-18C CART ASSEMBLY (continued) 1 Pump enclosure 10 4 Fan yoke Intake line 4 Filter 2 3 Retaining strap 4 Cooler 6 Spout 2 5 2 3 Hub extension 3 7 9 TOOLS REQUIRED: Screwdriver, adjustable wrench, hammer, and pliers. 1. Place base (item 5) on flat work surface with legs downward as shown above. Install wheels onto axle; making sure the hub extension is facing inward toward the base. Next place one push-nut (item 7) on axle and using a hammer, seat in place with a sharp blow.
PAGE 5
SET-UP / OPERATION 1. Always operate the Power Mister on a level surface. In the event the unit is tipped over or tilted more than 35 degrees, a built-in tip-over switch will shut off power to the pump and fan. Power will be restored when unit is placed in the upright position. 2. Fill cooler with clean fresh water (ice may be added) each time mister is used. Drain unused water at the end of use period. 3. Aim mister downwind for best results.
PAGE 6
SET-UP / OPERATION (continued) To prepare models PM-18S and PM-18FO for operation: Fan / pump enclosure 1. Take empty cooler to the approximate location to be misted. Carrying a full cooler will be difficult to do since it will weigh approximately 80-pounds. 2. Fill cooler. 3. Place the fan / pump enclosure on the Igloo cooler as shown at left. * 4. Make sure intake line and filter are in bottom of cooler. 5. Follow Set-up / Operation instructions on page 5.
PAGE 7
ASSEMBLED VIEW AND REPLACEMENT PARTS LIST FOR PM-18FO & PM-18S 6 8 2 1 11 10, 12 4 3 7 16 14 8 13 5 Issue Date: 3-11-05 ITEM # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 QTY. 1 1 1 1 1 1 1 5 1 2 2 2 1 2 1 1 1 P/N 6399099 63991002 58381001 58364003 44115001 58299008 44114001 44108001 44105001 3443032 2480700 0004901 63924001 44108002 44104001 58467001 2489800 18 1 2490000 19 1 2419200 Rev. Date: 9-12-07 Rev.
PAGE 8
MAINTENANCE WARRANTY TPI CORPORATION - P.O. Box 4973 Johnson City, TN 37602-4973 (800) 251-0382 TPI Corporation’s Guaranteed Customer Satisfaction Warranty States: ELECTRICAL SHOCK HAZARD • • If you are ever dissatisfied with the quality of our workmanship or in the design or function of our equipment, you may return it to us for repair, replacement, or credit at our discretion. A returned goods number will be issued at the time you contact us.