Product Manual

SERIES 5100
TASKMASTER
Installation Instructions
FS5102TASKMASTER SERIES
UNIT MOUNTED LINE VOLTAGE SUMMER FAN SWITCH
FOR USE ON EITHER 480 OR 600 VOLT SUPPLY
READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING SWITCH. BE SURE TO DE-ENERGIZE
POWER SOURCE TO UNIT BEFORE INSTALLING SWITCH. BE SURE TO INSTALL THE APPROPRIATE
MODEL SWITCH ON THE CORRECT UNIT.
1.) Disconnect heater from supply.
2.) Remove appropriate knockouts for switch being used. Refer to Fig. 1.
Models 5102 thru 5105 - Fig. 2
Knockout group is located on heater back center approximately 1 1/8” (29mm)
from bottom of heater.
Models 5107 thru 5120 - Fig. 3
Knockout group is located on heater back approximately 3 1/4” (83mm) from bottom of heater with the 9/16”
(14mm) diameter knockout located approximately 3 3/4” (95mm) to the right of the back center.
Models 5125 thru 51100 - Fig. 4
Knockout group is located on heater back approximately 1 3/4” (44mm) from bottom of heater with the 9/16”
(14mm) diameter knockout located approximately 5” (127mm) to the left of the back center.
Fig. 2 Fig. 3 Fig. 4
3.) Remove paper backing from “Fan-Heat” decal, align with large knockout hole and affix to heater back with
“Heat” toward bottom of heater.
4.) Attach switch bracket assembly to heater back with the two No. 8 sheet metal screws supplied.
5.) Push knob on switch shaft and check alignment with decal.
6.) Wire switch according to wiring diagram located on inside of heater bottom panel. Attach switch leads 7 & 9
to terminals 7 & 9 on terminal board.
7.) After installation is complete, restore power and check for proper operation.
Note: For summer fan operation only, place thermostat in OFF position.
0.875
1.1565
2.3125
Ø0.5625
(22MM)
(29MM)
(59MM)
(14MM)
REMOVE FOR
FS5102
FIG. 1
Form 56628-008
ECO 1-5719