Product Manual

ManualsBrandsTPI ManualsCeiling + Wall HeatersFan-Forced Electric Heater — 10,000 Watt, 34,100 BTU

SERIES 5100

TASKMASTER

INSTALLATION INSTRUCTIONS

FSW5112 TASKMASTER SERIES

REMOTE (WALL MOUNT) LOW VOLTAGE SUMMER FAN SWITCH

LOW VOLTAGE SWITCH FOR USE ON TASKMASTER HEATERS WITH SUFFIX CODE “CA1” ONLY.

THIS ACCESSORY PACKAGE CONTAINS A REMOTE FAN SWITCH AND A LOW VOLTAGE RELAY FOR UNIT

MOUNTING.

READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING SWITCH. USE THIS SWITCH ONLY ON

UNITS WITH 24 VOLT CONTROL CIRCUITS. BE SURE TO DE-ENERGIZE POWER SOURCE TO UNIT BEFORE

INSTALLING SWITCH. ALL CONDUCTORS FROM SWITCH TO UNIT MUST BE COPPER. ALL WIRING TO BE

IN ACCORDANCE WITH THE NATIONAL ELECTRIC CODE (NEC) AND EXISTING LOCAL CODE

REQUIREMENTS.

1.) Disconnect heater from power supply.

2.) Remove 7/8” diameter knockout from heater back

for control wiring switch:

Models 5102 thru 5105

7/8” diameter knockout is located 2 1/2” to right of

heater back center and 3 5/16” from bottom of

heater.

Models 5107 thru 5120

7/8” diameter knockout is located 5 1/2” to left of

heater back center and 1 1/2” from bottom of heater.

Models 5125 thru 51100

7/8” diameter knockout is located 5 1/16” to left of

heater back center and 3 5/8” from bottom of heater.

3.) Mount switch assembly to remotely located utility

box.

4.) Wire switch according to wiring diagram located

on inside of heater bottom panel. Attach leads 2

and 4 from switch to heater terminals 2 and 4 on

heater terminal board.

5.) Fig. 1 Mount low voltage relay in wiring compartment-

Slip long leg of relay base under raised section of

control mounting plate and attach diagonally

opposite corner of relay base to control mounting

plate with the No. 8 sheet metal screw supplied.

NOTE: Models 5102 thru 5105

Relay is mounted next to heater power

terminal block.

Models 5107 thru 51100

Relay is mounted next to heater control

terminal board.

6.) Wire relay according to wiring diagram located on

inside of heater bottom panel. Attach relay leads

6, 8, 7 & 9 to terminals 6, 8, 7 & 9 on terminal

board.

7.) Remove paper backing from “Fan-Heat” decal and

affix to utility box cover with fan toward on and heat

toward off.

8.) After installation is complete, restore power to

heater and check for proper operation.

NOTE: For summer fan operation only thermostat

must be in OFF position.

2-5 kw 7-20 kw

25-50kw

FORM 8950

ECO 1-5719