Product Manual

SERIES 5100
TASKMASTER
FSW5111 TASKMASTER SERIES
REMOTE (WALL MOUNT) SUMMER FAN SWITCH
LINE VOLTAGE SWITCH FOR USE ONLY ON TASKMASTER HEATERS WITH A POWER
SUPPLY OF 208, 240 OR 277 VOLT SERVICE.
READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING SWITCH. DO NOT USE
THIS SWITCH ON UNITS WITH 480 OR 600 VOLT MOTOR CIRCUIT. BE SURE TO
DE-ENERGIZE POWER SOURCE TO UNIT BEFORE INSTALLING SWITCH. ALL
CONDUCTORS FROM SWITCH TO UNIT MUST BE COPPER (NEC) AND EXISTING LOCAL
CODE REQUIREMENTS.
1.) Disconnect heater from power supply.
2.) Remove 7/8” diameter knockout from heater back for control wiring from switch.
Models 5102 thru 5105
7/8” diameter knockouts located 2 1/2” to right of heater back center and 3 5/16” from bottom
of heater.
Models 5107 thru 5120
7/8” diameter knockouts located 5 1/2” to left of heater back center and 1 1/2” from bottom of
heater.
Models 5125 thru 5150
7/8” diameter knockouts located 5 1/16” to left of heater back center and 3 5/8” from bottom of
heater.
Models 5155 thru 5175
7/8” diameter knockouts located 5 1/16” to right of heater back center and 3 7/16” from bottom
of heater.
Models 5180 thru 51100
7/8” diameter knockouts located 5 1/16” to right of heater back center and 5” from bottom of
heater.
3.) Mount switch assembly in remotely located utility box.
4.) Wire switch according to wiring diagram located on inside of heater bottom panel. Attach leads
7 & 9 from switch to heater terminals 7 & 9 on heater terminal board.
5.) Remove paper backing from “Fan-Heat” decal and affix to utility box cover with fan toward on
and heat toward off.
6.) After installation is complete, restore power to heater and check for proper operation.
NOTE: For summer fan-operation only thermostat must be in OFF position.
FORM: 8949
ECO 1-5719