Product Manual

SERIES 5100
TASKMASTER
Installation Instructions
FS5101 TASKMASTER SERIES
UNIT MOUNTED LINE VOLTAGE SUMMER FAN SWITCH
FOR USE ON UNITS WITH 208, 240, 277 VOLT SUPPLY ONLY
READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING SWITCH. BE SURE TO DE-
ENERGIZE POWER SOURCE TO UNIT BEFORE INSTALLING SWITCH. BE SURE TO INSTALL
THE APPROPRIATE MODEL SWITCH ON THE CORRECT UNIT.
1.) Disconnect heater from power supply.
2.) Remove appropriate knockout for switch being used. Refer to Fig. 1.
Fig. 1
Models 5102 thru 5105 - Fig. 2
Knockout is located on heater back center
approximately 1 1/8” (29mm) from bottom of
heater.
Models 5107 thru 5120 - Fig. 3
Knockout is located on heater back approximately
3 1/4” (83mm) from bottom of heater with the 1/2”
(13mm) diameter knockout located approximately
3 3/4” (95mm) to the right of the back of center.
Models 5125 thru 51100 - Fig. 4
Knockout is located on heater back approximately
1 3/4” (44mm) from bottom of heater with the 1/2”
(13mm) diameter knockout located approximately
5” (127mm) to the left of the back center.
Fig. 2 Fig. 3
FORM: 8948
ECO 1-5719
Fig. 1