Product Manual

HORIZONTAL -- AIR DISCHARGE MOUNTING
SHOWN IN: FIGURE 5 & 6
Swivel hanger brackets may be used to suspend unit
heaters from either the wall (figure 5) or the ceiling
(figure 6). Attach hanger base “A” to top of heater with
the four 5/16 X 18 caps screws and lockwashers (pro-
vided in envelope).
Attach main hanger frame “B” to wall or ceiling in
desired location using appropriate hardware or welding.
Lift heater into position inserting 5/8” bolt with lockwasher
through hole in main hanger frame, tightening to welded
nut on hanger base within two turns of being tight.
Swivel heater to desired position, tighten bolt.
VERTICAL -- AIR DISCHARGE MOUNTING
SHOWN IN: FIGURE 7
5
Attach short angle brackets “A” to back of heater with
four 5/16 X 18 capscrews “B”, lockwashers “F”. Be sure
vertical leg of angle brackets face top and bottom of
heater.
Attach inverted U frames “D” to short angle brackets
with four 5/16 X 18 capscrews “K”, washers “L”,
lockwashers “M” and nuts “N”.
Attach long angle brackets “J” to inverted frames “D”
with four 5/16 X 18 capscrews “K”, washers “L”,
lockwashers “M” and nuts “N”.
Attach heater and bracket assembly to ceiling in
desired location using customer supplied equipment
sufficient to support the assembly.
INSTALLATION INSTRUCTIONS
TASKMASTER -- 5100 SERIES UNIT HEATER (part 2)
Figure 5
WALL MOUNT
HORIZONTAL DISCHARGE
NOTE: When mounting heater using 5/16” all thread
rod (by others) do not screw the rod more than 1/2”
beyond the inside of the case.
Figure 6
CEILING MOUNT
HORIZONTAL DISCHARGE
B
A
A
B
FIGURE 7
CEILING MOUNT VERTICAL DISCHARGE
V5150 SHOWN. SEE INSTALLATION INSTRUCTIONS
PROVIDED FOR V51100.