Product Manual

versatility when mounted vertically. (55 thru 75 kW only)
Modular control kits for field installation. Tthermostat,
summer fan switch, heat recovery thermostat. All kits with
spade terminals .
Single point terminal board wiring of integral control kits.
24 volt low voltage control circuit standard on all models.
Roomy control box with access door locked into position
by two (2) 1/4 turn fasteners for ease of installation.
Revised 03/07
Form XXXX
ATTENTION: Read carefully before attempting to install,
operate or service the TaskMaster Unit Heater. Retain
these installation instructions for future use.
TASKMASTER
5100 SERIES
Horizontal or Vertical Mounting
Industrial / Commercial
Unit Heater
PRODUCT FEATURES
Forced air electric unit heater available in 208, 240/208,
and 480 volt, 3 phase as standard.
Ten standard heating capacities of 55.0 KW/187,715 BTUH
thru 100.0 KW/341,300 BTUH.
Specially designed inlet louver allows the fan to pull cool
air evenly across the high mass all-steel element.
Outward drawn venturi and adjustable louver assembly
further directs the outlet air in a uniform pattern to meet
specific air pattern requirements in either the horizontal
or vertical mounting position.
Optional wall/ceiling or vertical mounting brackets (as
required).
Four position weld nuts supplied in case top and back
for field mounting by threaded rods or eye bolt with chain.
(Hardware supplied by others).
Optional radial or anemostat diffusers lending air pattern
INSTALLATION
INSTRUCTIONS
& PARTS LIST
IMPORTANT: OWNER SHOULD RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
55 THRU 100 kW MODELS