Product Manual

OIPM P/N 8997
4 OF 14
YES - SERIES INSTALLATION
ALL Fostoria YES models require some assembly. Four steps are required to complete the assembly and installation.
Tools required: (2) ¾” socket or box wrenches.
Parts required: the two screws required to secure wall/ceiling
bracket to a suitable surface are not supplied with heater. You must
use 5/16” bolts and at washers to mount this bracket.
Step 1: Install (1) side rotating stop over bolt
and into curved slot (as shown at right) on
each side of heater.
Step 2: Assemble hanger to heater per
hanger assembly detail. No tools are required.
Step 3: Secure wall/ceiling mounting bracket
to appropriate surface that will support a min.
weight of 100 lbs continuously. NOTE: all mounting hardware to
mount hanger to wall/ceiling bracket is supplied with heater.
Step 4: Assemble unit to mounting bracket following instructions of
chosen mounting option below.
Hanger Assembly Detail
Ceiling Mount Option
Wall Mount Option #1
Wall Mount Option #2
HANGER
RUBBER
WASHER
STEEL
WASHER
BAR
KNOB
ROTATING
STOP
BOLT
NUT
STEEL
WASHER
STEEL
WASHER
NYLON
WASHER
TOP OF HEATER
.
BOLT
STEEL
WASHER
NUT
STEEL
WASHER
NYLON
WASHER
ROTATING
STOP
BOLT
STEEL
WASHER
NYLON
WASHER
ROTATING
STOP
STEEL
WASHER
NUT
FALLING OBJECTS HAZARD
FIRE HAZARD
CHUTES D’OBJETS LES RISQUES
RISQUE D’INCENDIE
• Serious injury or death may occur.
Blessures graves ou la mort peuvent
survenir.
• Read and follow all safety information
and instructions in box below.
Lire et suivre toutes les consignes de
sécurité et les instructions dans la boîte
ci-dessous.
• Mounting bracket supplied with YES models MUST
be used to support heater.
• Installer MUST be certain surface that bracket
is mounted to will support 100 lbs of weight
continuously.
• Rotating stops MUST be installed as shown above.
• Do not mount heater upside down (See nameplate
label for “TOP” of heater.)
• The bottom of these units must be mounted at
least 6 ft. off the oor and the top 2 ft. from the
ceiling.
• Do not suspend ANY other equipment from this
bracket. One heater per bracket