Product Manual

7 OF 14
OIPM P/N 8997
WIRING (continued)
Attach feeder cable or cable kit to heater as shown in
photograph at right for the single-phase models indicated.
3-Phase Models
Attach feeder cable or cable kit to heater as shown in the photograph
at left for the following 3-phase models.
YES-1524-1A
MAXIMUM OVER CURRENT PROTECTION 80 MAPS
USE COPPER WIRE ONLY
240 VOLTS 60 HZ
1-PHASE
15KW
CYCLINGOVER-TEMP. SWITCH
THERMOSTAT
CONTACTOR
COIL
240 V / 2500W ELEMENT
(TYP. 6)
CONTACTOR
NON-CYCLING
THERMOSTAT
FAN MOTOR
FAN
CON
FUSE FLNR-40 250V
GROUND LUG
GND
TERMINAL
BLOCK
L4
L3
L2
L1
L4
L3
L3
L4
L3
L2
L1
T4
T3
T2
T1
64
1
3
Ground lug is located directly
below fuse as shown in upper
left corner. Securely attach
green wire to this lug.
Attach circuit conductors at these
lugs. Refer to label shown for
phase identication
Ground Lug
Securely attach
green wire to this lug.
Attach circuit conductors to
the lugs on the contactor.
Refer to label shown for phase
identication.
FES-1520-3A YES-1520-3A
FES-1524-3E YES-1524-3E
FES-1548-3E YES-1548-3E
FES-1560-3A YES-1560-3A
FES-3048-3A YES-3048-3A
FES-3060-3A YES-3060-3A