Product Manual

ISSUE DATE 10-09-03 REV. DATE 2-26-09 REV. LEVEL: 14 ECO 1-6073 OIPM P/N 8329 PG 5 OF 17
CHECKING YOUR SHIPMENT
Upon receipt of your shipment, check the carton(s)
for damage.
Any accessory items ordered for heater will be
shipped in their own carton.
Claims for damaged material or shortages that were
not evident upon receipt of shipment must be
reported to carrier and Fostoria customer service
immediately.
Before starting to install the heater, make sure that
all components and accessories ordered are
available.
INSTALLER QUALIFICATIONS
Only firms or individuals qualified to perform work
in accordance with the applicable specifications for
electrical equipment should be engaged to install
Fostoria MTM systems. Consult local building
inspectors, fire mar
shals, your local Fostoria
representative or the factory for guidance.
INSTALLATION PLANNING
INSTALLER RESPONSIBILITY
National and local codes and ordinances together
with specifications provided by Fostoria
Industries, Inc. comprise the information needed
for proper installation. The installer must furnish
all materials that have not been purchased from
Fostoria Industries or its representatives. It is the
installer’s responsibility that the materials and
methods of installation result in a job that is
workmanlike and in keeping with all applicable
codes.
In storage areas where stacking of materials may
occur, the installer must provide signs which
specify the maximum stacking height so as to
maintain the required clearances to combustibles.
ELECTRICAL BONDING (GROUNDING)
A protective non-
corrosive conductor terminal
must be firmly attached to a protective bonding
conductor (both supplied by customer). This must
then be secured to the heater with the supplied
green screw and lock washer in the heater
wireway to ensure a proper bond (ground).
LAYOUT DESIGN
When positioning heaters, keep in mind the clearance to combustible materials, lights, sprinkler heads,
overhead doors, storage areas with stacked materials, gas and electrical lines, parked vehicles, cranes, etc.
Refer to page six (6) for minimum clearance to verify that a safe installation condition exists.
The Fostoria Mul-T-Mount Series offers the highest watt density and heating efficiency in an electric
infrared heater. All models are listed for spot-
heat or total building heat indoors (excluding residential),
or for totally unprotected outdoor applications. Fixtures are also listed
for recessed applications, such as
in ceilings or canopies.
2-Lamp models are available in either Stainless Steel or a Hi-Temp Brown Powder Coated finish.
3-Lamp models are only available in Stainless Steel.
The specially designed “T” Tab wire channel allows for one-man installation.
No asbestos or mercury is used in the manufacture of these heaters.