Installation Guide

Existing Powerline Device
(for demonstration only)
* TL-WPA4220 (European version) is used for demonstration in this guide.
Pair the powerline devices.
4
3
Relocate the extender to the Wi-Fi “dead” zone on the same electrical circuit. Connect your
devices to the internet using the default SSID (network name) and password on the label at
the top of the extender.
Note: If the Power LED does not blink, press the Pair
button again.
Press the Pair button on the existing powerline
device for 1 second. The Power LED starts blinking.
A
Within 2 minutes, press the Pair button on the new
extender for 1 second. The Power LED starts blinking.
B
When the Powerline LED on the new extender turns
on, the pairing process is complete.
Existing Powerline Device
Quick Installation Guide
Within 2 minutes
Powerline
Check the new extender’s Powerline LED . Is it on?
Step 4>
Step 3>
2
New Extender
TL-WPA4220
1
Plug in the new extender near one of your existing powerline devices.
If you cannot nd this SSID in your Wi-Fi network list, this may mean the Wi-Fi Move feature
has automatically copied over the existing wireless settings (see back for more information).
In this case, use the SSID and password of your existing powerline network to connect.
New Extender TL-WPA4220
Blinking
On
Attention
Wall Outlet Power Strip
Plug powerline devices into wall outlets instead of power strips.
Blinking
* Images may dier from actual products.