Instructions for Use

Updat
How to use OpenVPN to access your home network throu
Routers (new logo)?
Conguration Guide
In the OpenVPN connection, the home network can act as a server, and the remote device can access the server through the router which acts as
VPN feature, you should enable OpenVPN Server on your router, and install and run VPN client software on the remote device. Please follow the ste
Step1. Set up OpenVPN Server on Your Router
1. Log in to the web-based interface of the router. If you don’t know how to do that, please refer to
How do I log into the web-based Utility (Management Page) of TP-Link wireless router?
2. Go toAdvanced>VPN Server>OpenVPN, and selectEnable VPN Server.
Note:
Before you enable VPN Server, we recommend you congure Dynamic DNS Service (recommended) or assign a static IP address for the route
Time with the internet.
For the CG-NAT ISP: Comporium and Direct link - radio service, provide the customera private IP, that will cause you can’t use the OpenVPN
the ISP andask them to oer a Statis IP address.
The rst time you congure the OpenVPN Server, you may need toGeneratea certicate before you enable the VPN Server.
3. Select theService Type(communication protocol) for OpenVPN Server: UDP, TCP.
4. Enter aVPN Service Portto which a VPN device connects, and the port number should be between 1024 and 65535.
5. In theVPN Subnet/Netmaskelds, enter the range of IP addresses that can be leased to the device by the OpenVPN server.
This Article Applies to:

Case 1: Only one router in the home network map