User Manual

Archer CR700

AC1750 Wireless Dual Band DOCSIS Cable Modem Router User Guide

Figure 5-17

Step 2: Press and hold the WPS button of the client device directly.

Step 3: The WPS LED flashes for two minutes during the Wi-Fi Protected Setup process.

Step 4: When the WPS LED is on, the client device has successfully connected to the modem

router.

Refer back to your client device or its documentation for further instructions.

II. Enter the client device’s PIN on the modem router

Use this method if your client device has a Wi-Fi Protected Setup PIN number.

Step 1: Enter the PIN number from the client device in the field, as shown in the following figure.

Then click Connect button.

Figure 5-18

Step 2: “Device has been added successfully!” will appear on the screen, which means the

client device has successfully connected to the modem router.



Note:

1) The WPS LED on the modem router will light green for five minutes if the device has been

successfully added to the network.

2) The WPS function cannot be configured if the Enable Router’s PIN switch is off. Please

make sure the Enable Router’s PIN switch is on before configuring the WPS.

5.4.3 Guest Network

Choose menu “Advanced

→

Wireless 2.4G

→

Guest Network”, you can configure the

advanced settings of your guest network.