Download

Quick Installation Guide

AC1350 Wireless Dual Band Router

If your Internet connection is through an Ethernet cable from the wall

instead of through a modem, connect the Ethernet cable directly to the

router’s Internet port, then follow step 4 and 5 to complete the hardware

connection.

Verify that the hardware connection

is correct by checking these LEDs.

2.4G

Internet

Power

Note: If the 2.4G LED and 5G LED are oﬀ,

please press the WPS/Wi-Fi On/O button on

the rear panel for 2 seconds, and then check the

LEDs again in a few seconds.

Connect the Hardware

Turn on the router.

Modem

Power adapter

Router

Internet

Connect the modem to the

Internet port on your router

with an Ethernet cable.

Turn oﬀ the modem, and remove

the backup battery if it has one.

Turn on the modem, and

then wait about 2 minutes

for it to restart.

PAGE 1
Quick Installation Guide AC1350 Wireless Dual Band Router Power adapter Connect the Hardware If your Internet connection is through an Ethernet cable from the wall instead of through a modem, connect the Ethernet cable directly to the router’s Internet port, then follow step 4 and 5 to complete the hardware connection. 4 Router Internet Power adapter 1 Turn off the modem, and remove the backup battery if it has one. 2 Connect the modem to the Internet port on your router with an Ethernet cable.
PAGE 2
Configure the Router B Create a new username and password and click Confirm. Then follow the step-by-step instructions of the Quick Setup to complete the initial configuration. 1. Connect your computer to the router (Wired or Wireless) Q1. What can I do if the login page does not appear? Wired Turn off the Wi-Fi on your computer and connect the devices as shown below.