User Guide

TL-WR720N 150Mbps Wireless N Router
 Static IP - Connections which use static IP address assignment.
The Router can not detect PPTP/L2TP/BigPond connections with your ISP. If your ISP uses one
of these protocols, then you must configure your connection manually.
4.5.2 LAN
Choose menu “Network→LAN”, and then you can configure the IP parameters of the LAN on the
screen as below.
Figure 4-13 LAN
 MAC Address - The physical address of the Router, as seen from the LAN. The value can't
be changed.
 IP Address - Enter the IP address of your Router or reset it in dotted-decimal notation
(factory default: 192.168.0.1).
 Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
 Note:
1. If you change the IP Address of LAN, you must use the new IP Address to login the Router.
2. If the new LAN IP Address you set is not in the same subnet, the IP Address pool of the
DHCP server will change accordingly at the same time，while the Virtual Server and DMZ
Host will not take effect until they are re-configured.
4.5.3 MAC Clone
Choose menu “Network→MAC Clone”, and then you can configure the MAC address of the
WAN on the screen below, Figure 4-14:
Figure 4-14 MAC Address Clone
-29-