User Guide

7
The following parts are located on the rear panel:
¾ Power (48V): 48V indicates the input voltage of the power
adapter provided with this TL-SF1008P Switch. The Power socket
is where you will connect the power adapter.
¾ PoE Ports (1-4): These ports support PoE function which
integrates power and data onto one the same cable. Once the
device you connect to the switch is identified, the switch will
supply power through the PoE port, and then you can use it as a
10/100Mbps Auto-Negotiation RJ45 Ethernet port. The working
status can be indicated by the corresponding LEDs on the front
panel.
¾ Ethernet Ports (1-8): Besides the 4 PoE ports, the TL-SF1008P
Switch is also equipped with the other four 10/100Mbps
Auto-Negotiation RJ45 ports without PoE function. Once the
network devices are connected to these 8 ports through the
network cable, the switch will make them plug and play according
to the Auto-MDI/MDIX detection. The working status can be
indicated by the corresponding LEDs on the front panel.
Note
Make sure the PDs you connected to the switch are complaint with
IEEE 802.3af.