User Guide TL-SF1005D TL-SF1008D TL-SF1016D 10/100Mbps Desktop Switch Rev:3.0.
FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1） This device may not cause harmful interference. 2）This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. CE Mark Warning This is a class B product.
The Switch mentioned in this User Guide stands for TL-SF1005D/TL-SF1008D/TL-SF1016D 10/100Mbps Desktop Switch without any explanation. For Simplicity, we will take TL-SF1016D for example throughout this Guide. TL-SF1016D can be mounted on a wall. Refer to the steps below to mount the Switch on a Wall. 1. Drill two holes into the wall. Insert a screw into each hole and leave a part of its head exposed. 2. Place the two wall-mounting slots over the screws and slide the Switch down to fasten it.
The Switch's LEDs are located on the front panel: LED Status Indication Power On The switch is powered on. Off No Power Source. *Please check if the power cord is connected to the Switch properly, and make sure the power is ON. Ethernet On LED The corresponding ethernet port is connected to a network device. Flashing Data is being transmitted or received. Off No device is connected to the corresponding port.
