User Guide TL-POE10R PoE Splitter Rev:3.0.
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2011 TP-LINK TECHNOLOGIES CO., LTD.
FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. CE Mark Warning This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. SAFETY NOTICES ¾ Do not use this product near water, for example, in a wet basement or near a swimming pool. ¾ Avoid using this product during an electrical storm.
CONTENTS Package Contents ................................................................... 1 Chapter 1 1.1 1.2 Introduction ........................................................ 1 Overview of the Product .............................................. 1 Features ...................................................................... 2 Chapter 2 Identifying External Components..................... 2 Chapter 3 Connecting the PoE Splitter ............................. 3 Appendix: Specifications ...
Package Contents The following items should be found in your package. ¾ TL-POE10R PoE Splitter ¾ One Ethernet (CAT5 UTP) Cable ¾ One Power Cable ¾ This User Guide ) Note: Make sure that the package contains the above items. If any of the listed items are damaged or missing, please contact with your distributor. Chapter 1 Introduction 1.1 Overview of the Product Thank you for choosing the TL-POE10R PoE Splitter. The PoE Splitter fully complies with IEEE 802.3af standard, and can work with all IEEE 802.
1.2 Features ¾ Complies with IEEE 802.3, IEEE 802.3u, IEEE 802.3af standards ¾ Data and Power carried over the same cable ¾ Supports optional 5V DC, 9V DC or 12V DC power supply ¾ Supports Plug-and-Play for the devices ， without any configuration ¾ Elegant appearance with space-saving mini size Chapter 2 Identifying External Components Power-mode switch: You can choose the DC output of 12V, 9V or 5V by turning the switch to the left or right.
LAN OUT: Connect to the Ethernet device with CAT5 UTP cable to transmit data. DC OUT: Connect to the power port of the Ethernet device with the provided power cable to supply the power of 5V, 9V or 12V DC. PWR: Power LED, a steady green light indicates that the PoE Injector can supply power.
3. Connect the LAN OUT port to the Ethernet device with CAT5 UTP cable for data transmitting. 4. Connect the DC OUT port to the power port of the same Ethernet device with the provided power cable. )Note: The power of Ethernet device is suggested to be under 10W. Now, the Ethernet device can work normally with data and power. The topology of this network is as follows.
Appendix: Normal Standards Voltage Output Power Output Ports Cabling Type LED Safety & Emissions Specifications IEEE 802.3, IEEE 802.3u, IEEE 802.
