User Guide

TD-W8960N 300Mbps Wireless N ADSL2+ Modem Router User Guide
 Note:
In this type, there should not have any IPv6 WAN connections. If there are IPv6 WAN connections,
the page will prompt you to delete all the IPv6 WAN connections.
4.4.15.2 IPv4inIPv6
Choose
“Advanced Setup”““IP Tunnel”“IPv4inIPv6”. You can see the 4in6 tunnel
configuration screen, this screen allows you to configure the static routes (shown in Figure 4-62).
Figure 4-62
Click the Add button in Figure 4-62, and you can configure the 6in4
tunnel on the next screen as
shown in Figure 4-63.
Figure 4-63
 Mechanism: DS-Lite, this type is used in the situation that your WAN connection is IPv6 while
LAN connection is IPv4.
 Associated WAN Interface: Select a WAN connection from the drop-down list. Only the
connected WAN connections can be shown in the drop-down list.
 Associated LAN Interface: Select a LAN connection from the drop-down list. Only the
connected LAN connections can be shown in the drop-down list.
 AFTR: Enter the IPv6 address of the remote node.
Click Save/Apply to make the configuration take effect.
 Note:
In this type, there should not have any IPv4 WAN connections. If there are IPv4 WAN connections,
the page will prompt you to delete all the IPv4 WAN connections.
55