User Guide

TD-W8960N 300Mbps Wireless N ADSL2+ Modem Router User Guide

Figure 4-51

2. Enter the following data:

 IP Version: Select the version of IP.

 Destination IP Address/prefix length: The Destination IP Address is the address of the

network or host that you want to assign to a static route.

 Interface: Select the Interface name in the text box, or else, the default Use Interface will be

adopted for the Static Route.

 Gateway IP Address: If you select the IPoE or IPoA mode for Interface, the screen above

will display this item, you should type the Gateway address correctly, and the other option for

Interface will adopt the default Gateway address for the Static Route.

3. Click Save/Apply to and then you will see you settings as shown in Figure 4-50.

To remove a static rout

ing entry:

1. Select the Remove check box according to the entry in the Figure 4-50.

2. Click the Remove button, and the entry will be deleted.



Note:

Gateway IP address should be correctly configured if IP based Interface (IPoE, IPoA) is selected.

4.4.10.3 RIP

Choose “Ad

vanced Setup”“Routing”“RIP”, you can see the screen as shown in Figure 4-52.

Figure 4-52