User Guide

TD-W8960N 300Mbps Wireless N ADSL2+ Modem Router User Guide
 Remove: Se
lect the check box in the table above and then click Remove, the corresponding
interface will be deleted in the table.
4.4.2.2 ATM-EoA-IPoE
If
your ISP provides an IPoE connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface and select EoA option for DSL Link Type (4.4.1.1 ATM Interface).
2. Click the Add button on the screen (as shown Figure 4-7). Select WAN Service Interface over
ATM PVC on the next scr
een (as shown Figure 4-8).
3. If your ISP provides an IPoE connection, select IPoE option for the WAN service type on the
screen (as shown Figure 4-9), and click Next button to continue.
4.
Enter parameters in the following blanks to configure the WAN IP Address and click Next.
Figure 4-15
 Obtain an IP address automatically: Select this option, the router will be able to obtain IP
network information dynamically from a DHCP server provided by your ISP.

Note:
1) The response message from a DHCP server typically contains a number of configuration
parameters (DHCP options) for the router. The DHCP options include IP network information,
and also the vendor-specific options. In some cases, the router is implemented to perform
user-defined operations (as shown below). You can implement your own treatment of all such
options.
2) If the router is functioning as a DHCP client, it must identify itself in option 61 (client-identifier)
in every DHCP message. DUID/IAID is portion of option 61.
 Option 60 Vendor ID: The option code 60 used to identify Vendor class.
23