User Guide

Meet Your Temperature and Humidity Sensor

Measure the temperature and humidity of the environment and send you instant

notications when the environment changes. It is suitable for green houses, bedrooms,

nursery, incubators, and wine cellars.

Quick Start Guide

Smart Temperature and

Humidity Sensor

7106509722 REV1.0.0

*Images may dier from actual products.

Open the Tapo app and tap the button.

Select Sensors and then your model.

Follow the app instructions to complete

setup.

2. Set Up Your Sensor

Before You Start

A Tapo Hub is required. Make sure your

Tapo Hub is successfully added via the

Tapo app.

Remove the battery insulation tab to power

up your sensor. The LED should blink.

Note: If the LED is not blinking, use a pin to press the Reset

button for 5 seconds to reset your sensor and enter pairing

mode.

1. Power Up Your Sensor1

Take your sensor to the preferred location.

Option 1

Single press the Reset button. Your hub

should make a voice prompt.

3. Test Your Sensor

Option 2

Blow on the sensor detector. The

temperature and humidity displayed on

the Tapo app should change.

Reset

Sensor

Detector

LED

Battery Pinhole

Use a pin to press and

remove the cover

Reset Button

Single press: Eective range test

Press for 5s: Reset and enter

pairing mode

CR2450

PAGE 1
Meet Your Temperature and Humidity Sensor Before You Start Measure the temperature and humidity of the environment and send you instant notifications when the environment changes. It is suitable for green houses, bedrooms, nursery, incubators, and wine cellars. Quick Start Guide A Tapo Hub is required. Make sure your Tapo Hub is successfully added via the Tapo app. Sensor Detector Smart Temperature and Humidity Sensor 1 Power Up Your Sensor 1.
PAGE 2
(The installation height should not be higher than 2 meters.) Option 1: Hang with the Lanyard 4. ? How to replace the battery Option 2: Use Adhesive Magnets a. Stick the included adhesive magnets to the back panel. Option 3: Use 3M Adhesives b. Magnetically attach the sensor to metallic surfaces. 1. Use a pin to press and remove the cover. a. Stick the included 3M adhesives to the back panel. 3M 3M 3M 3M 4. 4 Place Your Sensor Metallic Surface 2. Replace the battery with a fresh cell. 3.