Operation Manual

326
For example: Configure the IP address as 10.10.70.22, mask as 255.255.255.0 and
gateway as10.10.70.1. The detailed command is shown as the figure below. Enter the
command and press Enter.
[TP-Link]: ifconfig ip 10.10.70.22 mask 255.255.255.0 gateway 10.10.70.1
4） Configure the parameters of the FTP server which keeps the upgrade firmware. Later
you can download the firmware to the switch from the FTP server. The format of the
command is: ftp host xxx.xxx.xxx.xxx user xxxxx pwd xxxxx file xxxxxx.bin.
Here take the following parameters of the FTP server as an example. IP address is
10.10.70.146; the user name and password for login to the FTP server are both 123;
the name of the upgrade firmware is t2500_28tc_up.bin. The detailed command is
shown as the following figure. Enter the command and press Enter.
[TP-Link]: ftp host 10.10.70.146 user 123 pwd 123 file t2500_28tc _up.bin
5） Enter the upgrade command and press Enter to upgrade the firmware. After a while,
the prompt “You can only use the port 1 to upgrade” will display in the hyper terminal
shown as the following figure.
[TP-Link]: upgrade
You can only use the port 1 to upgrade.
6） When the prompt “Are you sure to upgrade the firmware[Y/N]:” displays, please enter Y
to start upgrade or enter N to quit upgrade shown as the following figure. The # icon
indicates it is upgrading. After upgrading, the [TP-Link] command will display.
Are you sure to upgrade the firmware[Y/N]: y
###############################################
###############################################
###############################################
###################################
[TP-Link]:
7） Please enter start command to start the switch shown as the following figure. Then you
can login to the CLI command window and manage the switch via CLI command.
[TP-Link]: start
Start . . . . . . . .
◀
* * * * * * * * * * * * * * * * * *
User Access Login
* * * * * * * * * * * * * * * * *
User:
When you forget the login user name and password, you can enter reset command after
entering into bootUtil menu to reset the system. The system will be restored to the factory
default settings, and the default login user name and password are both admin.
Return to CONTENTS