Operation Manual

271
14.2.1 Notification Config
On this page, you can configure the notification function of SNMP.
Choose the menu SNMP→Notification→Notification Config to load the following page.
Figure 14-8 Notification Config
The following entries are displayed on this screen:

Create Notification
IP Mode:
Select the IP mode.
IP Address:
Enter the IP Address of the management Host.
UDP Port:
Enter the number of the UDP port used to send notifications.
The UDP port functions with the IP address for the
notification sending. The default is 162.
User:
Enter the User name of the management station.
Security Model:
Select the Security Model of the management station.
Security Level:
Select the Security Level for the SNMP v3 User.
• noAuthNoPriv:
No authentication and no privacy security
level are used.
• authNoPriv: Only the authentication securit
y level is
used.
• authPriv:
Both the authentication and the privacy
security levels are used.
Type:
Select the type for the notifications.
• Trap: Indicates traps are sent.
• Inform:
Indicates informs are sent. The Inform type has a
higher security than the Trap type.
Retry:
Specify the amount of times the switch resends an inform
request. The switch will resend the inform request if it
doesn’t get the response from the management station
during the Timeout
interval, and it will terminate resending
the inform
request if the resending times reach the specified
Retry times.