Operation Manual

17
Recurring Mode:
Specify the DST configuration in recurring mode. This
configuration is recurring in use:
 Offset: Specify the time adding in minutes wh
en Daylight
Saving Time comes.

Start/End Time: Select starting time and ending time of
Daylight Saving Time.
Date Mode:
Specify the DST configuration in Date mode. This
configuration is one-off in use:
 Offset: Specify the time adding in minutes when Dayli
ght
Saving Time comes.

Start/End Time: Select starting time and ending time of
Daylight Saving Time.
Note:
1. When the DST is disabled, the predefined mode, recurring mode and date mode cannot be
configured.
2. When the DST is enabled, the default daylight saving time is of Europe in predefined mode.
4.1.5 System IP
Each device in the network possesses a unique IP Address. You can log on to the Web
management page to operate the switch using this IP Address. The switch supports three
modes to obtain an IP address: Static IP, DHCP and BOOTP. The IP address obtained using a
new mode will replace the original IP address. On this page you can configure the system IP of
the switch.
Choose the menu System→System Info→System IP to load the following page.
Figure 4-7 System IP
The following entries are displayed on this screen:

IP Config
MAC Address:
Displays MAC Address of the switch.