Operation Manual

131
Unidirection: Displays whether the local client supports unidirectional OAM
operation.
Some devices support unidirectional OAM operation. These
devices provide an OAMPDU-based mechanism to notify the
remote OAM entity wh
en one direction of a link is
non-operational and therefore data transmission is disabled.
Link Monitoring:
Displays whether the local client supports link monitoring
function.
Variable Request: Displays whether the local client supports variable request
. If
supports, the local client can send some variable requests to
the remote client to learn about the link status from the
response of the remote client.
PDU Revision:
Displays the Information TLV revision of Information OAMPDU.
Operation Status: Displays the operating status of the OAM connection.
 Disable: OAM is disabled on this port.

LinkFault: The link has detected a fault and is transmitting
OAMPDUs with a link fault indication.

PassiveWait: The port is in passive mode and is waiting to
see if the peer device is OAM capable.

ActiveSendLocal: The port is in active mode and is sending
local information.

SendLocalAndRemote: The local port has discovered the
peer but has not yet accepted or rejected the configuration
of the peer.
 SendLocalAndRemoteOK: T
he local device agrees the OAM
peer entity.

PeeringLocallyRejected: The local OAM entity rejects the
remote peer OAM entity.

PeeringRemotelyRejected: The remote OAM entity rejects
the local device.

NonOperHalfDuplex: Since Ethernet OAM functions are not
designed to work completely over half-
duplex ports. This
value indicates Ethernet OAM is enabled but the port is in
half-duplex operation.
Loopback Status: Displays the loopback status.

No Loopback: Neither the local client nor the remote client
is in the loopback mode.
 Local Loopback: The local client is in the loopback mode.

Remote Loopback: The remote client is in the loopback
mode.

Remote Client
The local client part shows the information of the remote OAM entity.
Mode:
Displays the OAM mode of the remote client.
Mac Address:
Displays the MAC address of the remote client.