Operation Manual

Configuring ACL ACL Configurations
Configuration Guide
521
Choose the menu ACL > Policy Binding > Binding Table to load the following page.
Figure 2-14 Verifying the Policy Binding
2.2 Using the CLI
2.2.1 Configuring ACL
Follow the steps to create different types of ACL and configure the ACL rules.
You can define the rules based on source or destination IP addresses, source or
destination MAC addresses, protocol type and so on.

Configuring the MAC ACL
Step 1 configure
Enter global configuration mode
Step 2 mac access-list
access-list-num
Input an MAC ACL ID to enter MAC Access-list mode. If it is a new ID , the ACL will be created and the
switch will enter MAC Access-list mode.
access-list-num:
Enter an ACL ID between 0 and 499.