Installation Instructions

JetStream 12-Port 10GBase-T Smart Switch with 4 10G SFP+ Slots
02 Introduction
LED Status Indication
SYS
Flashing The switch is working normally
On/Off The switch is working abnormally
FAN
Green All the fans work properly
Yellow Not all the fans work properly
Off The switch is working abnormally
Link/Act
(Por t 1-12)
Green
On
There is a 10Gbps device connected to the
corresponding port but no activity
Flashing
Data is being transmitted or received
Yellow
On
There is a 100/1000Mbps device connected to the
corresponding port but no activity
Flashing
Data is being transmitted or received
Off No device is connected to the corresponding port
Link/Act
(Port 13-16)
Green
On
There is a 10Gbps device connected to the
corresponding port but no activity
Flashing
Data is being transmitted or received
Yellow
On
There is a 1000Mbps device connected to the
corresponding port but no activity
Flashing
Data is being transmitted or received
Off No device is connected to the corresponding port
Reset
Press this button for 5 seconds or above to reset the software setting back to
factory default settings.
100M/1000M/10G RJ45 Port
Designed to connect to the device with a bandwidth of 100Mbps, 1000Mbps or
10Gbps. Each has two corresponding Link/Act LEDs , the left one is 10Gbps and the
right one is 100/1000Mbps.
SFP+ Port
Designed to install the SFP module. T1700X-16TS features 4 individual SFP+ ports
and supports 1G or 10G SFP module connection.