Installation Instructions

JetStream 12-Port 10GBase-T Smart Switch with 4 10G SFP+ Slots

15Connection

Chapter 4 Connection

4.1 Ethernet Port

Connect a Ethernet port of the switch to the computer by RJ45 cable as the following

figure shows.

Figure 4-1 Connecting the RJ45 Port

RJ45 Port

RJ45 Cable

4.2 SFP+ Port

Connect an SFP/SFP+ transceiver or an SFP+ cable to the SFP+ port. Make sure the

SFP+ module minimum bend radius is met when using the SFP+ cable.

The SFP+ ports support 10G connection by default. If you are using a gigabit SFP

module, please configure the speed of the corresponding SPF+ port as 1000M.

Figure 4-2 Inserting the SFP+ Module

SFP+ Port

SFP+ Transceiver

4.3 Verify Installation

After completing the installation, please verify the following items:

■

There are 5 to 10cm of clearance around the sides of the device for ventilation and the

air flow is adequate.

■

The voltage of the power supply meets the requirement of the input voltage of the

device.