User Instructions

Table Of Contents

Wire Your Switch

Disconnect wires from the old switch.

Turn o the circuit breaker. Then

remove the old wallplate of the wall

switch and label the wires.

Connect the wires to the smart switch as

shown below.

Note: No need to distinguish between Line and Load wires.

Ground: Usually green or copper.

Neutral: Usually white, not connected to the dumb switch.

Line/Load: Usually black, and connected to the dumb

switch.

If you are unsure, consult a qualied electrician.

Line up the switch with the mounting

holes. Secure it with screws.

Attach the wallplate and turn on the

circuit breaker. Then the wiring is nished.

Set Up Your Switch

STEP 2

SET UP

Tap the button in the app. Select Switches

and then your model. Follow the step-by-step

app instructions to set up your smart switch.

DOWNLOAD APP

Get the Tapo app from the App Store or

Google Play.

STEP 1

PAGE 1
Wire Your Switch 1 Turn off the circuit breaker. Then remove the old wallplate of the wall switch and label the wires. Set Up Your Switch 3 Connect the wires to the smart switch as shown below. Line up the switch with the mounting 4 holes. Secure it with screws. Attach the wallplate and turn on the 5 circuit breaker. Then the wiring is finished. STEP 1 DOWNLOAD APP Get the Tapo app from the App Store or Google Play. OR STEP 2 Tap the button in the app. Select Switches and then your model.
PAGE 2
Appearance Button Explanations Reset Restart Press and hold for about 5s to reset Wi-Fi while keeping other settings. Press and hold for about 10s to restore your switch to factory default settings. Press to restart your switch. LED Status On/Off Button LED Reset Restart Solid amber Blinking amber & green Starting up; disconnected from cloud. Ready for setup. Blinking green Connecting to Wi-Fi. Stay green for 30s Connected to Wi-Fi. Solid red Disconnected from Wi-Fi.
PAGE 3
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.