User's Guide

5
Chapter 1
Get to Know About Your Extender
1. 2. 1. LED Explanation
You can check the extender’s working status by following the LED Explanation table.
Name Status Indication
Signal
Solid blue
The extender is connected to your router’s wireless network
and is in a suitable location.
Solid red
The extender is experiencing poor signal strength. Try
relocating it closer to your router.
Blinking WPS connection is in progress.
Off No wireless connection is established.
Power
On/Off The extender is on or off.
Blinking The system is starting up or firmware upgrade is progress.
1. 2. 2. Port and Button Description
Ports or Buttons Description
(WPS Button)
Press the WPS button on your host router, and immediately press the WPS
button on the extender for 1 second. The Signal LED of the extender should
change from blinking to solid on, indicating successful WPS connection.
RESET Button
With the extender powered on, use a pin to press the RESET button for 1
second. The extender will reset and reboot.
Ethernet Port
Connect your Ethernet-only device to the Ethernet port of the extender to join
the network.
Note: Make sure the device is being used within 0-40℃ and stored within -40-70℃.