user manual

TL-WR700N
150Mbps Wireless N Mini Pocket Router
- 4 -
 LED
Status Indication
Solid Blue
The device is working properly.
Blinking
The system is booting. Please wait 15 seconds.
The device is unable to connect to the network.
Table 1-1 The LED Description

Note:
For Repeater/ Bridge/ Client mode, the LED may blink for up to 3 minutes. If the devices
blink for more than 3 minutes, please verify that the password is entered correctly. If it still
doesn’t work, the device may be too far away from your primary router. Try moving it closer,
then wait for 3 minutes and check if the LED is solid blue.
 LAN/WAN: This LAN/WAN port works as LAN in AP/Repeater/ Bridge/Client mode and as
WAN in Router mode. As LAN, it connects the Router to the local PC; as WAN, it enables
you connect the DSL/cable Modem, or Ethernet.
 RESET
：
It is used to reset the Router to its factory defaults. With the Router powered on,
use a pin to press and hold the RESET button (about 5 seconds) until the SYS LED
becomes quick-flash from slow-flash. And then release the button and wait the Router to
reboot to its factory default settings.
 Power Plug: Plug in standard electrical wall socket directly to power the Router.