user manual

15
Gigabit Smart Switch


Connect a Ethernet port of the Switch to the computer by RJ45 cable as the following
figure shown.
RJ45 Port
RJ45 Cable
Connecting the RJ45 PortFigure 4-1

Connect the SFP port to a SFP module. If an SFP transceiver (purchased separately)
is installed in a slot and has a valid link on the port, the associated RJ45 port will be
disabled and cannot be used.
Inserting the SFP ModuleFigure 4-2
Note:

When using the SFP port with a 100Mbps module or a gigabit module, you
need log on to the GUI (Graphical User Interface) of the Switch and configure its
corresponding Speed and Duplex mode on Switching
→
Port
→
Port Cong page.
For 100Mbps module, please select 100MFD while select 1000MFD for gigabit module.
By default, the Speed and Duplex mode of SFP port is 1000MFD.
Connection
SFP Port
SFP Module