user manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Hardware installation
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the Router
- Appendix A: Specifications
- Appendix B: Preventing Lightning
- Appendix C: FAQ
- Appendix D: Glossary
TL-R600VPN SafeStream Gigabit Broadband VPN Router User Guide
TM
53
Figure 4-51
¾ Enable Bandwidth Control - Enable or disable the Bandwidth Control.
¾ Line Type - Select the Line Type of the WAN port.
¾ Egress/Ingress Bandwidth – Enter the Egress and Ingress Bandwidth through the WAN
port.
4.11.2 Rule List
Figure 4-52
¾ Description - This is the information about the rules such as address range.
¾ Egress bandwidth - This field displays the max and mix upload bandwidth through the WAN
port, the default is 0.
¾ Ingress bandwidth - This field displays the max and mix download bandwidth through the
WAN port, the default is 0.
¾ Enable - This displays the status of the rule.
¾ Modify - Click “Modify” to edit the rule, click “Delete” to delete the rule.
To add/modify a Bandwidth Control rule:
Step 1: Click Add New…Modify shown in Figure 4-52, you will see a new screen shown in
Figure 4-53
Step 2: Enter the information like the screen shown below.