user manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Hardware installation
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the Router
- Appendix A: Specifications
- Appendix B: Preventing Lightning
- Appendix C: FAQ
- Appendix D: Glossary
SafeStream
TM
Gigabit Broadband VPN Router User GuideTL-R600VPN
26
4.4 DHCP
Choose menu “DHCP”, the next submenus are shown below.
Figure 4-12
Click any of them, and you will be able to configure the corresponding function. The detailed
explanations for each submenu are provided below.
4.4.1 DHCP Settings
Choose menu “DHCP→DHCP Settings”, you can configure the DHCP in the next screen (shown
in Figure 4-13).
The router is set up by default as a DHCP (Dynamic Host Configuration Protocol) server, which
provides the TCP/IP configuration for all the PCs that are connected to the router on the LAN.
Figure 4-13
¾ DHCP Server - Enable or disable the DHCP server. If you disable the Server, you must
have another DHCP server within your network or else you must manually configure the
computer.
¾ Start IP Address - This field specifies the first address in the IP address pool. The default
address is 192.168.0.100.
¾ End IP Address - This field specifies the end address in the IP address pool. The default
address is 192.168.0.199.