Quick Installation Guide

General Specifications Environmental and Physical Specifications
Specications
0˚C to 40˚C (32˚F to 104˚F)
-40˚C to 70˚C (-40˚F to 158˚F)
5% to 90% RH non-condensing
10% to 90% RH non-condensing
Operation Temperature
Storage Temperature
Storage Humidity
Operation Humidity
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of
directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.
The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce
この装置は、クラスA情報技術装置です。この装置を家庭環境で使用すると電波妨害を引き起こすことがあります。こ
の場合には使用者が適切な対策を講ずるよう要求されることがあります。
VCCI-A
Safety Information
Keep the device away from water, re, humidity or hot environments.
Do not attempt to disassemble, repair, or modify the device.
Do not use damaged charger or USB cable to charge the device.
Do not use any other chargers than those recommended.
Adapter shall be installed near the equipment and shall be easily accessible.
Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
Do not point or stare directly into the beam or into the optical port of the transceiver when it is operating, as this can
injure your eyesight.
IEEE 802.3, IEEE 802.3i, IEEE802.3u
Standards
1 SC ber optic; 1 RJ45 jackConnector
Twisted-Pair
10BASE-T: 2-pair UTP/STP of Cat. 3 or above (≤100m)
100BASE-Tx: 2-pair UTP/STP of Cat. 5 or above (≤100m)
External Power Adapter: 9V/0.6APower
For MC100CM/MC110CS: 1310nm
For MC111CS: 1550nm TX, 1310nm RX
For MC112CS: 1310nm TX, 1550nm RX
Wave Length
LED PWR, FX Link/Act, TP Link/Act
Fiber
For MC100CM:
62.5/125μm multi-mode (≤2km); 50/125μm multi-mode (≤2km)
For MC110CS/ MC111CS/MC112CS:
9/125μm single-mode ber (≤20km)
Explanation of the symbols on the product label
DC voltage
Indoor use only
RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic equipment
(WEEE). This means that this product must be handled pursuant to European directive
2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.
User has the choice to give his product to a competent recycling organization or to the retailer
when he buys a new electrical or electronic equipment.
Scenario 1: Connect Devices with and without Optical Interfaces
LC-SC Fiber Cable
Ethernet Device
with Optical Interfaces
Twisted-Pair Cable
Ethernet Device
without Optical Interfaces
Media Converter
10BASE-T/100BASE-TX Interface
100BASE-X (Fiber) Interface
Note: Please use one MC111CS and one MC112CS to work properly.
Scenario 2: Connect Devices without Optical Interfaces
SC-SC Fiber CableTwisted-Pair Cable Twisted-Pair Cable
Ethernet Device
without Optical Interfaces
Media Converter Media Converter
Ethernet Device
without optical Interfaces
10BASE-T/100BASE-TX Interface
10BASE-T/100BASE-TX Interface
PWR
TP
Link/Act
FX
Link/Act
10/100M
PWR
TP
Link/Act
FX
Link/Act
10/100M
For MC111CS/MC112CS
PWR
TP
Link/Act
FX
Link/Act
10/100M