Manualshelf

User Manual

ManualsBrandsTP-Link ManualsNetwork CardMC100CM
12
©2017 TP-Link 7106507660 REV5.0.1
For more information, please visit our website:
http://www.tp-link.com
MC100CM/MC110CS
Fast Ethernet Media Converter
Enlarge Your Ethernet Network
Package Contents: Converter, Power Adapter, User Guide, Purchasing Guide
TP_AUTO/TP_DIS: Set the TP port speed to Auto-Negotiation/FORCE.
TP_100M/TP_10M: Set the TP port’s speed.
LFP_ON/LFP_OFF: Enable or disable the LFP function.
TP_FDX/TP_HDX: Set the duplex mode for the TP port as
Full-Duplex/Half-Duplex.
You can set the speed and duplex via dierent switch combinations as
shown below.
Note:
1. It is recommended to leave the switches on TP_AUTO, TP_100M, TP_FDX and LFP_On to
accommodate most situations.
2. Please reboot the converter after conguring the switches.
Switch Combination
TP_AUTO, TP_100M, TP_FDX
TP_DIS, TP_100M, TP_FDX
(TP_DIS or TP_AUTO), TP_100M, TP_HDX
TP_DIS, TP_10M, TP_FDX
(TP_DIS or TP_AUTO), TP_10M, TP_HDX
Speed and Duplex
TP: AUTO
TP: FORCE,100M, FULL-Duplex
TP: FORCE,100M, HALF-Duplex
TP: FORCE,10M, FULL-Duplex
TP: FORCE,10M, HALF-Duplex
DIP Switches
TP_AUTO
TP_FDX
LFP_OFF
TP_100M
TP_DIS
LFP_ON
TP_10M
TP_HDX
1 2 3 4
Scenario 1: Connect Devices with and without Optical Interfaces
LC-SC Fiber Cable
Ethernet device
with optical interfaces
Twisted-Pair Cable
Ethernet device
without optical interfaces
Media Converter
10BASE-T/100BASE-TX interface
100BASE-X(Fiber) interface
Note:
1. Please use two Media Converters of the same model to work properly.
2. Please connect the TX port of one converter to the RX port of the other using a ber cable.
3. With the LFP (Link Fault Pass Through) function enabled, when one side of the link fails, the media converter
will disconnect the transmit link of the other side, thus minimizing the loss caused by link failure.
Scenario 2: Connect Devices without Optical Interfaces
Fiber CableTwisted-Pair Cable Twisted-Pair Cable
Ethernet device
without optical interfaces
Media Converter Media Converter
Ethernet device
without optical interfaces
10BASE-T/100BASE-TX interface
10BASE-T/100BASE-TX interface

Summary of content (2 pages)