User Guide

Need some help?
?
Visit www.tp-link.com/support
for technical support, user guides, FAQs,
warranty & more
Indicator LED
Main Dimmer Button & LED Satellite Dimmer Button & LED
Buttons Buttons
Starting up.Solid amber
Blinking amber
Blinking red rapidly
Blinking green
Solid red
Stay green for 30s
Blinking amber & green
Connecting to Wi-Fi.
Ready for setup.
The switch is being reset to
factory default settings.
Traveler 1 of main dimmer is
connected to Traveler 2 of satellite
dimmer. Please check wiring.
Disconnected from Wi-Fi.
Connected to Wi-Fi.
Wi-Fi LED
Specications
Safety Notice
Before installing, servicing or removing the switch, read and follow all
safety precautions including the following:
• CAUTION – Risk of Electric Shock – More than one disconnect switch
may be required to de-energize the equipment before servicing. A
circuit breaker which disconnects the Line and Neutral conductor
simultaneously is suitable. Ensure power is o at the circuit breaker
before removing or installing any switch. Use a non-contact voltage
tester to ensure the power is o.
• The Smart Switch must be installed and used in accordance with the
National Electric Code (NEC) or your local electrical code. If you are
unfamiliar with these codes and requirements, or are uncomfortable
performing the installation, consult a qualied electrician.
• Do not install the Smart Switch with wet hands or when standing on
wet or damp surfaces.
• Install only in a suitable UL Listed outlet box (suitable dimensions: H >
2.95 in./75 mm, W > 1.81 in./46 mm, D > 2 in./51 mm).
• Tighten terminal screws to 13 lbf-in.
Rating: 120V~ 60Hz
Load: 300W Incandescent 150W LED (MLV)
Operation temperature: 0~40℃
Dimming Type*: Leading Edge Dimming / TRIAC Phase
Cut
*It’s also suggested to contact your bulb’s Support to check
the supported dimming type of the bulb.
©2022 TP-Link
Indicator LED
Press to turn on / off your dimmer.
Restart
Reset
On/Off
Button
Press and hold for about 5s to reset Wi-Fi
while keeping other settings.
Press to restart your dimmer.
Decrease or increase the brightness.
Press and hold for about 10s to restore
your dimmer to factory default settings.
/
Indicate the dimmer location in the dark.
It turns on when light fixture is off.
Brightness
Indicators
Indicate the brightness of the light.
Position
Indicator
Press to turn on / off your dimmer.
On/Off
Button
Decrease or increase the brightness.
/
Indicate the dimmer location in the dark.
It is always on.
Position
Indicator
Appearance
This 3-Way Dimmer Kit has a main dimmer and a satellite dimmer. They cannot work separately or with traditional
3-way switches.
Main Dimmer Satellite Dimmer
Brightness Indicators
Dimmer Buttons
On/O Button
Wi-Fi LED
Position Indicator
Reset
Restart
Position indicator of the satellite
dimmer is always on.