Specifications

76
Choose the menu VLAN→802.1Q VLAN→Port Config to load the following page.
Figure 7-5 802.1Q VLAN – Port Config
The following entries are displayed on this screen:

VLAN Port Config
UN I T:
Select the unit ID of the desired member in the stack.
Select:
Select the desired port for configuration. It is multi-optional.
Port:
Displays the port number.
Link Type:
Select the Link Type from the pull-down list for the port.
• ACCESS:
The ACCESS port can be added in a single VLAN,
and the
egress rule of the port is UNTAG. The PVID is same
as the current VLAN ID. If the current VLAN is deleted, the
PVID will be set to 1 by default.
• TRUNK: The TRUNK port can be added in multiple VLANs.
The egress rule of the port is UNTAG if the arriving pack
et’s
VLAN tag is the same as the port’s PVID, otherwise the
egress rule is TAG.
The PVID can be set as the VID number
of any valid VLAN.
• GENERAL:
The GENERAL port can be added in multiple
VLANs and set various egress rules according to the different
VLANs.
The default egress rule is UNTAG. The PVID can be
set as the VID number of any valid VLAN.
PVID: Enter the PVID number of the port.