Specifications

380
Time:
Displays the time when the log event occurs. The log can get the
correct time after you configure on the System→System
Info→System Time Web management page.
Module:
Displays the module which the log information belongs to. You can
select a module from the drop-
down list to display the corresponding
log information.
Severity:
Displays the severity level of the lo
g information. You can select a
severity level to display the log information whose severity level value
is the same or smaller.
Content:
Displays the content of the log information.
Note:
1. The logs are classified into eight levels based on severity. The higher the information severity
is, the lower the corresponding level is.
2. This page displays logs in the log buffer, and at most 1024 logs are displayed.
18.2.2 Local Log
Local Log is the log information saved in switch. By default, all system logs are saved in log buffer
and the function of saving logs to the log file in the flash is disabled. On this page, you can set the
output channel for logs.
Choose the menu Maintenance→Log→Local Log to load the following page.
Figure18-4 Local Log
The following entries are displayed on this screen:

Local Log Config
Log Buffer:
Indicates the RAM for saving system log. The inforamtion in the
log buffer is displayed on the Log Table page. It will be lost when
the switch is restarted.
Log File:
Indicates the flash sector for saving system log. The inforamtion
in the log file will not be lost after the switch is restarted and can
be exported on the Backup Log page.