Specifications

206
Metric:
Set the metric value to be used as the metric of redistributed
routes. The valid value ranges from 1 to 16777214 and the
default is equal to Default Metric configured on Basic page.
Metric Type:
Set the OSPF metric type of redistributed routes. The default
is External Type 2.
Tag:
Set the tag field in routes redistributed. The valid value ranges
from 0 to 4294967295 and the default is 0.
NSSA Only: Set whether or not to
limit redistributed routes to NSSA areas.
The default is Disable.
10.9.9 ASBR Aggregation
You can configure address ranges for an ASBR on this page. The address range is used to
consolidate or summarize routes for external routes at an autonomous boundary. The result is that
a single summarized external route is redistributed to OSPF domain by the ASBR.
Choose the menu Routing→OSPF→ASBR Aggregation to load the following page.
Figure10-54 ASBR Aggregation
The following entries are displayed on this screen:

ASBR Aggregation Config
Process ID: Select the desired OSPF process for configuration.
IP Address: The IP address of the address range.
Subnet Mask: The subnet mask of the address range.
Tag: Set the tag fiel
d in redistributed address range. The valid value
ranges from 0 to 4294967295 and the default is 0.
NSSA Only:
Set whether or not to limit redistributed address range to
NSSA areas. The default is Disable.