Specifications

196
Passive Default: Co
nfigure the global passive mode settings for all OSPF
interfaces. Configuring this field will overwrite any present
interface level passive mode settings. OSPF does not form
adjacencies on passive interfaces, but does advertise
attached networks as stub ne
tworks. The default value is
'Disable'.
10.9.3 Network
You can configure networks contained by an area on this page. The interfaces, whose IP address
fall into the networks, will be imported to the associated area.
Choose the menu Routing→OSPF→Network to load the following page.
Figure 10-47 OSPF Network
The following entries are displayed on this screen:

Network Config
Process ID: Select the desired OSPF process for configuration.
IP Address: The IP address of the network.
Wildcard Mask:
The wildcard mask of the network. Normal subnet mask is also
supported.
Area ID:
The 32 bit unsigned integer that uniquely identifies the area to
which a router interface connects. If you assign an Area ID
which does not exist,
the area will be created with default
values. It can be in decimal format or dotted decimal format.

Network Table
Process: Select one OSPF Process to display its network list.
Select: Select the desired item for configuration. It is multi-optional.
IP Address: Displays the IP address of the network.
Wildcard Mask: Displays the wildcard mask of the network.