Specifications

173
RIP Distance: Set the RIP router distance.
Auto Summary:
If you select enable groups of adjacent routes will be
summarized into single entries, in order to reduce the total
number of entries The default is disable.
Default Metric:
Set the default metric for the redistributed routes. The valid
values are (1 to 15).
Redistribute Static: Choose to distribute Static router entries to RIP,
the default is
disable.
Redistribute OSPF: Choose to distribute OSPF router entries to R IP,
the default is
disable.
Redistribute Static
Metric:
Set the metric of redistributed Static routes. The valid values
are (0 to 15).
Redistribute OSPF
Metric:
Redistribute OSPF Metric
Set the metric of redistributed
OSPF routes. The valid values are (0 to 15).
Update Timer:
he timer interval to generate a complete response to every
neighboring gateway.
Timeout Timer:
Upon expiration of the timeout, the route is no longer valid and
set to unreachable.
Garbage Timer: Upon expiration of the garbage-
collection timer, the route is
finally removed from the tables.

Network Enable
You could add the network to enable RIP protocol here, so the interface in the network would
enable RIP protocol.

RIP Network List
Display the network enabled in the list. You could choose to delete the network here.
10.8.2 Interface Config
On this page, you can configure advanced parameters for the RIP.
Choose the menu Routing→RIP→Interface Config to load the following page.
Figure 10-28 RIP Interface Config
The following entries are displayed on this screen:

Interface Config
Select: Select the interface for which data is to be configured.
IP Address/Mask: The interface IP address and subnet mask.
It cannot be
changed here.