Specifications

141
The following entries are displayed on this screen:

Profile and Max Group Binding
UN I T: Select the unit ID of the desired member in the stack.
Select: Select the desired entry for configuration.
Port: It is multi-optional. Displays the port number.
Profile ID: The existing Profile ID bound to the selected port.
Max Group: The maximum multicast group a port can join.
Overflow Action:
The policy should be taken when the number of multicast group a
port has joined reach the maximum.
 Drop: drop the successive report packet, and this port cannot
join any other multicast group.
 Replace: When the number of the dynamic multica
st groups
that a port joins has exceeded the max-
group, the newly
joined multicast group will replace an existing multicast group
with the lowest multicast group address.
LAG: Displays the LAG number which the port belongs to.
ClearBinding: Click the ClearBinding
button to clear all profiles bound to the
port.
Note:
1. Multicast Filter feature can only have effect on the VLAN with IGMP Snooping enabled.
2. Multicast Filter feature has no effect on static multicast IP.
Configuration Procedure:
Step Operation Description
1 Create Profile Required. Configure
the Profile ID and mode on
Multicast→Multicast Filter→Profile Config page.
2 Configure IP-Range Required. Click Edit
of the specified entry in the IGMP Profile
Info table on Multicast→Multicast Filter→Profile Config
page to configure the mode or IP-range of the Profile.
3 Configure Profile Binding
for ports
Optional. Configure Profile Binding
for ports on
Multicast→Multicast Filter→Porfile Binding page.
9.5 Packet Statistics
On this page you can view the multicast data traffic on each port of the switch, which facilitates you
to monitor the IGMP messages in the network.