User manual

Network Topology
Hardware Overview
1
Installation Steps
Quick Installation Guide
EAP115-Wall
300Mbps Wireless N Wall-Plate Access Point
3
Front Panel
Rear Panel
LAN Port
EAPEAPEAP
Management Host
PoE Switch
Router
Internet
Clients
EAP Controller
RESET
LED
Pre-Installation Checklist
2
UPLINK+PoE Port
Connected to a PSE (Power Sourcing Equipment), such as a PoE switch, for
both data transmission and Power.
LED/Wi-Fi Button
LED: When the EAP is working normally, press the button to turn on/o the
LED.
Wi-Fi: In Standalone Mode, with the Wi-Fi Control enabled, press the button
to turn on/o the Wi-Fi and LED simultaneously.
LAN Port
Can be connected to a client device via an Ethernet cable.
RESET
With the EAP powered on, press and hold the button for about 5 seconds
until the LED ashes. The EAP will restore to factory default settings.
LED Indicator
On: Working normally/Initializing.
O: Working abnormally/Power o/LED is turned o.
Flashing:
Initialization: The LED ashes twice after initialization is complete.
Upgrade: The LED ashes once per second while upgrading.
Reset: The LED ashes ve times in quick session during the reset. The
EAP will then reboot.
The EAP115-Wall can only be powered by a PSE device, such as a PoE switch.
Connect the PoE switch to the UPLINK+PoE port with an Ethernet cable.
A DHCP server (typically a router) is required to assign IP addresses to the
EAPs and clients in your local network.
The management host can be in the same or dierent network segment with
the EAPs.
Before installation, be sure that you have the following items:
1. A pre-installed wall junction box
2. An RJ45 plug
3. A triangular screwdriver
4. A Phillips screwdriver
5. A PoE switch
EAP115-Wall can be mounted into either an 86mm wall junction box or a
standard EU wall junction box. The junction box should be pre-installed with
a running-in-wall Ethernet cable connected to a PoE switch.
86mm wall junction box
Standard EU wall junction box
LED/Wi-Fi Button