Quick Start Guide

TL-MR6400 User Guide
-45-
To setup a virtual server entry:
1. Click Add New….
2. Select the service you want to use from the Common Service Port list. If the Common
Service Port list does not have the service that you want to use, type the number of the
service port or service port range in the Service Port box.
3. Type the IP Address of the computer in the IP Address box.
4. Select the protocol used for this application, either TCP or UDP, or All.
5. Select Enabled to enable the virtual server.
6. Click Save.

Note:
It is possible that you have a computer or server that has more than one type of available service. If so,
select another service, and type the same IP address for that computer or server.
To modify an existing entry:
1. Click the Modify in the entry you want to modify.
2. Modify the information.
3. Click Save.
Click Delete in the entry you want to delete to delete an existing entry.
Click Enable/Disable All to make all entries enabled/ disabled.
Click Delete All to delete all entries.
Click Next to go to the next page and click Previous to return the previous page.

Note:
If you set the service port of the virtual server as 80, you must set the web management port on
Security → Remote Management page to be any other value except 80 such as 8080. Otherwise
there will be a conflict to disable the virtual server.