Quick Start Guide

Flip the page over to complete network setup.
If your internet comes from an Ethernet outlet, connect the router’s WAN port to it, then follow Step 4 and Step 5.
If you want to congure this new router as an access point to extend your network, refer to the Access Point Mode
section on the back page.
Connect the Hardware
Modem
Power adapter
Power adapter
Router
Connect the power adapter to
the router and turn it on.
Note: If the 2.4 GHz LED and 5 GHz LED are off, press and hold the
WPS/Wi-Fi button on the back for more than 5 seconds. Both the LEDs
should turn solid.
Check for the following LEDs to confirm the
hardware connection, then refer to the next
section to set up the internet.
Power on the modem, and
then wait about 2 minutes
for it to restart.
Unplug your modem, and remove
the backup battery if it has one.
Connect the powered-off modem
to the router’s WAN port with an
Ethernet cable.
* Images may dier from actual products.
Quick Installation Guide
AC1900 MU-MIMO Wi-Fi Router
WAN
WAN
POWER
POWER
Power
On
Internet
On
2.4GHz
On
5GHz
On
On / O